www.aja.com
27
Ki Pro Quad v5.2r3
Networking Ki Pro
Quad using the
Factory Default IP
If you don’t want to use DHCP to network Ki Pro Quad and also don’t want to set your
own static IP address, you can simply use a Default setting to use a factory setting of
10.65.74.65. This might be useful for an application where you directly connect a laptop
or computer to Ki Pro Quad and want to get networking quickly. Here are the steps to set
up this method of communication:
1. Use the Select buttons to navigate to parameter “50.1 IP CONFIG”, and then use the
Adjust buttons to select “Default”.
2. Set your laptop or desktop computer Ethernet IP address to 10.m.n.m (where m is not
65 and n is not 74).
3. Also on the computer, set the Subnet mask to 255.0.0.0 (most PCs default to the
proper netmask when the address is set—so you may not have to do anything here).
4. Run a browser on the computer and type “10.65.74.65” (the
Default
factory IP
address). You should now see Ki Pro Quad’s browser status screen.
Controlling Ki Pro
Quad from a web-
browser
To control Ki Pro Quad from a web browser on a network attached computer, you must
enter Ki Pro Quad’s IP address as a URL in the browser. For example, if Ki Pro Quad’s IP
address were “10.0.6.31”, you would then type into the web browser: http://10.0.6.31
This topic is explained in greater detail in
