-45-
[Setting TV/measuring equipment] V SIZE 60 simplified adjustment
1. Use the pattern generator and input the crosshatch signal.
2. Use the [/-] key of the jig remote control and adjust until the numbers of
squares in both upper and lower halves of screen satisfy the specification. (Fig. 2-6)
Fig.2-6
6 to 6. 5
6 to 6. 5
NTSC cross hatch
Fig.2-7 NTSC monoscope
Fig.2-8 NTSC cross hatch
Fig.2-9
A
B
NTSC cross hatch
MENU2 3
−
NTSC crosshatch
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
The number of squares must be 6 to 6.5.
2-4. V LINEA 60 NTSC vertical linearity adjustment
[Setting TV/measuring equipment]
1. Use the monoscope and input the LION mark signal.
2. Use the [/-] key of the jig remote control and set the value to either 1E, 1F or
20, and confirm that six circles are true circles. (Fig. 2-7)
Note : Upon completion of adjustment, check
V POS 60 (MENU 2-2 and V SIZE 60
(MENU 2-3)
. If they do not satisfy the specifications, re-adjust them.
MENU2 4
−
NTSC monoscope
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
True circle
[Setting TV/measuring equipment] V LINEA 60 simplified adjustment
1. Use the pattern generator and input the crosshatch signal.
2. Use the [/-] key of the jig remote control and set the value to either 1E, 1F or
20, and confirm that the squares are regular squares. (Fig. 2-8)
Note : Upon completion of adjustment, check V POS 60 (MENU 2-2 and V SIZE 60 (MENU
2-3). If they do not satisfy the specifications, re-adjust them.
MENU2 4
−
NTSC crosshatch
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
Regular square
2-5. OSD H 60 NTSC OSD horizontal position adjustment
[Setting TV/measuring equipment]
1. Use the pattern generator and input the crosshatch signal.
2. Adjust each distance of A (from to left end on screen) and B (from to right end on
screen) so that they are equal. (Fig. 2-9)
MENU2 5
−
NTSC crosshatch
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
A = B
ELECTRICAL ADJUSTMENT-10/13
d u
p a
t o
r
