-44-
[Setting TV/measuring equipment] H POS 60 simplified adjustment
1. Use the pattern generator and input the crosshatch signal.
2. Use the [/-] of the jig remote control and adjust so that the dot mark at the
center of crosshatch screen is positioned at the center mark on CRT and the numbers of
squares in the right and left on the screen are equal (A=B). (Fig. 2-2.)
Fig.2-2
CENTER
A
B
NTSC cross hatch
MENU2 1
−
NTSC crosshatch
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
A=B
2-2. V POS 60 NTSC vertical position adjustment
[Setting TV/measuring equipment]
1. Use the monoscope and input the LION mark.
2. Use the [/-] key of the jig remote control and adjust so that the center lines of
the right most and left most edges on the monoscope screen match with the center mark
on CRT. (Fig. 2-3)
Fig.2-3 NTSC monoscope
Fig.2-4 NTSC cross hatch
Fig.2-5 NTSC monoscope
MENU2 2
−
NTSC monoscope
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
CRT center = monoscope center line
[Setting TV/measuring equipment]V POS 60 simplified adjustment
1. Use the pattern generator and input the crosshatch signal.
2. Use the [/-] key of the jig remote control and adjust so that the dot mark at
the center of crosshatch matches with the center mark on CRT. (Fig. 2-4)
MENU2 2
−
NTSC crosshatch
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
The center on CRT matches with the center of crosshatch.
2-3. V SIZE 60 NTSC vertical size adjustment
[Setting TV/measuring equipment]
1. Use the monoscope and input the LION mark.
2. Use the [/-] key of the jig remote control and adjust until the number of
vertical scale in both top and bottom of screen satisfy the specification. (Fig. 2-5)
MENU2 3
−
NTSC monoscope
VIDEO
ADJUSTMENT MENU No.
SPEC
MODE
INPUT SIGNAL
Vertical graduation is 3.5 to 4.5 (90% to 94%)
ELECTRICAL ADJUSTMENT-9/13
d u
p a
t o
r
