(5)
Push the anode cap with your thumb in the direction of
arrow
1
as shown in the figure, then lift the cap in the
direction of arrow
2
to release the hook on one side.
(See Figure 2-3)
(6)
Turn over the anode cap on the side where the hook was
released and pull out the cap in the direction opposite to
that on which the cap was pushed. (See Figure 2-4)
Caution :
Do not pull out the anode cap straight up.
:
Do not pull the cap forcibly. After removing
the cap, check that the hook is not deformed.
Figure 2-3
3. ANODE CAP REINSTALLTION
Observe the cautions carefully so that no accident occurs
due to a defect in installing the anode cap and so it does
not come off.
3-1. Caution before Reinstalling
Never turn the anode cap after installing it
Never re-use the hook when it has been deformed
(1)
If the anode cap is turned after it is installed, it may come
off. Therefore, arrange the high-voltage cable before
attaching the anode cap. (See Figure 3-1)
(2)
If you have attached the anode cap before arranging the
high-voltage cable, arrange the cable carefully so the cap
does not turn.
3-2. Anode cap reinstallation
(1)
Use a clean cloth moistened slightly with alcohol to clean
the installation section. (See Figure 3-2)
Caution :
Check that the installation section is free from
dust, foreign matter, etc.
(2)
Coat the anode cap installation circumference with an
appropriate amount of the specified silicone grease (KS-
650N).
Caution :
Be careful that silicone grease does not enter
the anode button.
CRT
CRT
Anode cap
Hook
Hook
Anode cap
Hook
Anode button
CRT
Left
Right
Anode cap
Anode button
Installation
section
Figure 2-4
Figure 3-1
Figure 3-2
4
