Cut Off Adjustment
2-1. Use the pattern generator to input the white raster signal.
2-2. Using the volume keys on the jig remote controller, fix the figure of the brightest color on the screen to the level 127 and adjust
the other 2 cut off figures until a white picture appears on the screen. (Fig. 2-2)
Drive Adjustment
2-3. Using the volume keys on the jig remote controller, bring the figure of 4. G DRIVE up to more than 200 till the color becomes
greenish.
2-4. Reduce the numeric figure to the point where the greenish color disappears completely.
2-5. Use the volume keys on the jig remote controller to increase the numeric figure of 5. B DRIVE up to more than 200 till the color
becomes bluish.
2-6. Reduce the numeric figure to the point where the bluish color disappears completely.
2-7. Repeat the process of 2-1 to 2-6 for several times and adjust for whitest look.
Focus Adjustment
Input signal : Dot pattern
Adjustment point : SFR located at upper part of FBT (T601)
Measuring instrument : Pattern generator
• Adjust SFR which is located at upper part of FBT (T601) in order get the best focus point for the dot.
Screen Adjustment:
Input signal : No signal (No raster)
Adjustment point : SFR located at lower part of FBT (T601)
1.
Display the adjustment menu screen by using the jig remote controller.
2.
Press “0” key of 10 numeric channel keypad to display a horizontal single line
on the screen. (Fig. 2-2)
3.
Adjust by SFR located lower part of FBT (T601) until the horizontal single line
starts to gleam.
4.
Repeat step 2. and return to the adjustment menu screen.
3-1. SUB BRIGHT Sub-bightness Adjustment / Adjustment Menu Screen :
PAGE 3-2 (make sure of the order)
Input signal : Color bar (Stair step)
Measuring insrument : Pattern generator
1. Adjust the 2nd scale from the right to just visible brightness by using the
volume keys on the jig remote controller.
PAGE 3
15
