8
14
Align one of the plastic spacers with the holes
on the enclosure poles and the legs.Then,
using one of the long bolts, insert it through
the enclosure pole, the spacer and then the
leg. Secure this together with washers, and
nuts. DO NOT TIGHTEN.
16
21
22
20
24
23
15
18
19
13
Carry mesh/poles and lay on trampoline
bed with upper poles toward the center
of the trampoline (as shown above).
Select one enclosure pole and align
holes on lower section with holes on
one leg extension (F from the Parts List)
ENCLOSURE ASSEMBLY
Refer to PARTS LIST for identification of parts.
Important: Do not use your trampoline and enclosure until you have thoroughly read and understand all instructions
and warnings provided.
17
Pull the drawstrings at the bottom of the
enclosure together and tie very tightly.
When done correctly, this should draw
the bottom edge of the mesh tightly
under the top rail of frame.
Using the longer piece of strapping sewn
to the mesh, wrap it down, under,
and around the top rail until it comes
back out. (See steps 20, 21, & drawing “A”)
The straps should look like this when
done properly. Next, pull firmly down
on the short strap so the drawstring
returns back under the top rail.
The mesh will capture the pad cover
edging helping to secure it in place.
Tie the long and short ends into a knot.
Do this with all lower enclosure straps.
Working your way around the trampoline,
select the next enclosure pole and attach
it to the next leg extension (F), repeating
steps 14-16 until all poles are attached.
Firmly pull down pad cover edging
so that padding completely covers
top rail. Pull down into place.
Slide enclosure pole foam up and work
mesh drawstring down between enclosure
pole and top rail so that drawstring is below
top rail around the perimeter of trampoline.
Bundle the loose ends of the Enclosure
Cinch-Cord together and secure with
plastic tie. Warning - failure to do this step
may result in serious injury, strangulation or
death.
Secure all top mesh straps in tight
bowties. Then, tighten all enclosure
pole bolts and nuts. Finally, cover
exposed threads with thread protectors.
