OPERATIION
OPERATIION
11
12
Press button to activate the supply aire flap to auto swing, if you push this button
again, the flap stops immediately.
Set vertical vanes to the front position during COOLING/DRY operation if humidity is
high.
If the vertical vanes are set to the left-most or right-most position, condensation may
form around the air outlet and drip off.
Do not move the flap with your hands when the air conditioner is running.
Use the button on the remote control to adjust the position of the flap. If
you move the flap by hand, the factual flap position and the flap position on the
remote control may no longer match. If this should happen, shut off the unit, wait
for the flap to close, and then turn on the unit again; the flap position will now
be normal again.
NOTES
Some functions of remote controller will not be available when the unit does not
support them! By resetting the remote control, shall totally remove the battery
for 10 seconds.By pressing the " " and " " together to switch the temperature
display between degrees Celsius and degrees Fahrenheit at OFF status.
When the A.C operates with heat mode with set temperature 17
℃
, Press “-“
button twice within 2 seconds will activate 8 Degree heating. The indoor display
shows the temperature as 8
℃
ADJUSTING THE AIR FLOW DIRECTION
Press and CLEAN button together to activate the horizontal louver. If you push
them together again to stop it immediately.(Only for selected models)
ENGLISH
