Airwell AIRFLOW2020, Руководство по установке и эксплуатации

Страница: 97 / 140

27
6 - ELECTRIC CONNECTIONS
ELECTRICAL CONNECTION DIAGRAM
This unit is required reliable earthing
before usage, otherwise might cause
death or injury.
All electrical operations should be performed by trained personnel having the necessary requirements
by the regulations in force and being informed about the risks relevant to these activities.
The unit must be installed with an Creepage Breaker near the power supply and must be effectively
earthed.
A creepage breaker must be installed adjacent to the power supply
Set the electric leakage protector according to the relevant electric technical standards of the State.
After wire connection, check it again and make sure the correctness before power on.
Do not use water pipes to earthing connection of the unit
PRINCIPAL ELECTRICAL PANEL
L-PRO
Low Pressure Switch Protection
DAMP
Damper
H-PRO High Pressure Switch Protection 4-WAY Four Way Valve
Extension Expansion Board S-FAN Supply Fan
3G 3G Module E-FAN Exhaust Fan
ALL Cumulative Alarm COMP Compressor
HUM
Humidity sensor
EEV
Electronic Expansion Valve
PUMP
Condensate Drain Pump
SW1 / SW2
DIP Switch