8
Airwallet PRO300
Installation Guide
• As standard, the Airwallet PRO is wired out with a no-voltage
relay normally open (NO), to send start signals to the machine. If
the installation requires a normally closed (NC) relay the Airwallet
PRO can be opened and the wire can be moved from the NO
terminal to the NC terminal.
• To reset the Airwallet PRO disconnect the power source for
15 seconds. If you want to change or delete information about
the device, such as name, price, start signal, or feedback type
go to the Airwallet Dashboard and find the device under “Your
Locations”.
Airwallet PRO Status Lights
The following table describes the Airwallet PRO status light
sequences and what they indicate. The status lights are
located inside the Airwallet PRO, and should only be used when
troubleshooting the installation. The status lights are mounted on
the printed circuit board at the opposite end of the cable inlet.
Light
Status/Description
Off
Airwallet PRO is unpowered
One solid green, one off
Airwallet PRO is on and working
properly
Two solid green
Airwallet PRO is starting up. This
process will take 15 seconds.
One solid green, one shortly flashing
(<1 sec.)
Airwallet PRO is receiving data from
the Airwallet App
