AirSpeed 1050 Installation Guide
DUG01545
Airspan Commercial and Internal Use
20
4 Installation of AirSpeed 1050
4.1 Mounting
AirSpeed 1050 is installed on a pole (side or top) or wall and comes fully assembled. Prior to
installation of the AirSpeed unit the mounting bracket must first be affixed in place on the Pole or Wall.
Caution:
Proper local rigging and hoisting practices should be followed when installing the AirSpeed
1050.
Note:
When installing the unit, a minimum gap of at least 35cm above the unit (so as to NOT block
airflow) and a minimum gap of 20cm below the unit should be kept. In the event of any heat radiating
source below the unit widen the gap.
Recommended:
When installing the unit, care should be taken so that the unit should be distanced
from any obstructions above that can interfere with “clear sky” conditions needed for good GPS
reception. In the event this is unavoidable there is the option to use a remote GPS installation using
an external antenna.
Note:
There should be no other devices mounted on either side of the unit so as NOT to interfere
with the antennas.
Note:
Installation should take into consideration the antenna(s) and Sector(s) direction for maximum
coverage.
Note:
Pole installation should be so the antenna(s) are positioned parallel to the street for maximum
coverage.
Figure 5: Positioning Overview
