Airrex AH-300, Руководство пользователя

Страница: 5 / 20

5
NOTICE FOR SAFETY
TIPS BEFORE INSTALLATION....
Do not put this heater on unstable
surface of ground such as inclined or bumpy.
(The heater may not work properly.)
You must take out the plug from the
outlet, if there is a flash of lightening
or thunder or you don’t use it for a long time.
(Otherwise, it is exposed to the danger of
electrical shock, short circuit or a fire.)
Do not put an excessive physical shock to
the remote controller, nor disassemble it arbitrarily.
(it arbitrarily.)
Do not operate this heater in the
place where it gets wet by the humid such
as bathroom.
(It may cause an electrical short circuit or
an electrical shock accident.)
1. Make sure the safety in the place where you wish to use this heater.
▶
The ground surface and surrounding should be
plain and non-flammable, and solid.
▶
You need to have sufficient space surrounding the
heater at least 15cm from the wall and the left & right
side, at least 1m distance from the ceiling and the front
side without any obstacle.
▶
You need to use exhaust duct incase of operating
in small spaces.
(Recommended Duct specification :
75mmØ(Diameter) x 5meter long-aluminum duct)
(Be sure there must not be rain drops into the exhaust
duct end.)
(You must ventilate frequently with fresh air by opening
window or fan.)
▶
You must put an extinguisher beside the heater.
▶
There must not be direct sun light, excessive heat near
the heater.
▶
After you fix the installation, lock the caster for avoiding
unexpected movement.
▶
Do not use this heater near fabri curtain, carpet or
plastic or vinyl curtain which may cover th heater in case
of falling down by the wind or by any physical force,
which may cause a fire.
2. You must use Diesel or kerosene as fuel.
▶
If you use other fuel, it may cause an
excessive soot or trouble of malfunction.
▶
Incase of refueling make sure the
heater is turned OFF.
▶
To be made by the manufacturer or his service
agent who should be contacted if there is an oil
leakage.
▶
Regulations concerning the disposal of oil when
scrapping the appliance have to be followed.
3. The proper electricity is 220/230V, 50Hz. It will be
applied and adjusted as per customer's request.
You must supply power as per its requirement only
once it is adjusted.
▶
The heater must not be located immediately below
a socket-outlet.
▶
Positioned so that the plug is accessible.
Do not shower water to the heater
directly, nor use benzene, thinner, alcohol
for cleaning.
(Otherwise, it is exposed to the danger of
electrical shock, short circuit or a fire.)
In case of storing this heater, be sure that
you store it in the dry places indoor instead
of hot and humid environment.
(Otherwise, it gets rusty or goes into trouble.)
Call your local after sales service agent
in case the power cord is damaged.
(Otherwise, it is exposed to the danger of
electrical shock, short circuit or a fire.)
CAUTION
If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or similarly qualified
person in order to avoid a hazard.