AirMaid 5000 T, Руководство по эксплуатации, Страница: 5 / 8

5
2. INSTALLATION
3. BEFORE POWER-UP
4. USE
The AirMaid T-type generator may only be installed upright
as shown in the following photograph. Never install the unit
in any other orientation or so the input/exhaust pipes are not
in the same horizontal plane!
Be sure it is not exposed to mechanical elements such as
vibration, moisture, etc. The input air must be clean and filtered
(using a minimum EU3-class filter) and may not exceed a tempera-
ture of 40°C.
As standard equipment the generator is delivered with a 5m power cable without an electrical
plug. An authorized electrician should be used to attach the power cable to a two-pole circuit
breaker.
1. Verify the installation was correctly performed.
2. Check that the exhaust air from the generator leads only to the desired area for treatment.
3. Ensure that no people work or visit the treatment area during its operation.
The main power switch and a rotary knob for ad-
justing ozone production from 0 – 100 % is behind
the door.
On the front panel you will also see a fuse holder.
Please note that the fuse requirement is 2AT.
As standard equipment the generator is delivered
with Ø110mm couplings on the input and
output ducts.
1. CHECK THE PRODUCT
Make sure that all ordered products have been delivered and that there are no visible damages. Any
deviations shall always be reported to the dealer or the manufacturer. Please read the entire user ma-
nual before beginning the installation.
1x 2000T/5000T
AirMaid® Ozone Generator
1 X User manual
2000T/5000T
Stand
(Optional)