AIRLUX ATIB64BK, Инструкция по использованию

Страница: 50 / 52

50
INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carefully, in conformity of the following drawing.
Fitting - installing:
•
The cut out sizes are:
Reference Cut-size
ATIB64BK 560 x 490 mm
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or device can be higher than the
hob.
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
•
The strips on the mural edges need to be heat-resistant.
•
Do not install the hob above a non- ventilated oven or a dishwasher.
•
To ensure good air circulation of the electronic device, maintain a space of
20 mm
under
the bottom of the hob casing.
•
If a drawer is placed under the work, avoid putting flammable objects in this drawer (e.g.
sprays) or non-heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect
the cutout edge, apply a coat of varnish or special sealant. Particular care must be given
when applying the adhesive joint supplied with the hob to prevent any leakage into the
supporting furniture. The gasket guaranties a correct seal when used in conjunction with
smooth worktop surfaces.
•
The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. Respect a distance of at least 760 mm if you do not
have further instructions.
•
The connection cable cannot be subjected to mechanical constraint (e.g. a drawer) after
construction.
•
WARNING: Use only hob guards designed by the manufacturer of the cooking appliance
or indicated by the manufacturer of the appliance in the instructions for use as suitable or
hob guards incorporated in the appliance. The use of inappropriate guards can cause
accidents.
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).