2
3
NOTE TO PHYSICIAN: Injection in the skin is a traumatic
injury. It is important to treat the injury surgically as soon as
possible. DO NOT DELAY treatment to research toxicity. Tox-
icity is a concern with some exotic coatings injected directly
into the blood stream. Consultation with a plastic surgeon or
reconstructive hand surgeon may be advisable.
FLUIDS UNDER HIGH PRESSURE FROM SPRAY OR
LEAKS CAN PENETRATE THE SKIN AND CAUSE
EXTREMELY SERIOUS INJURY, INCLUDING THE
NEED FOR AMPUTATION.
NEVER
point the spray gun towards anyone or at any part
of the body.
NEVER
put hand or fingers over the spray tip. Do not use
rag or other materials over your fingers. Paint will penetrate
through material and into the hand.
NEVER
try to stop or deflect leaks with your hand or body.
ALWAYS
have gun tip guard in place when spraying.
ALWAYS
lock gun trigger when you stop spraying.
ALWAYS
remove tip from the gun to clean it.
NEVER
try to "blow back" paint, it’s not an air sprayer.
ALWAYS
follow the
PRESSURE RELIEF PROCEDURE,
as shown on page 8, before cleaning or removing the spray
tip or servicing any system equipment.
Be sure equipment safety devices are operating properly
before each use.
ALWAYS
tighten all fluid connections before each use.
If any fluid appears to penetrate your skin, get
EMERGENCY CARE AT ONCE.
DO NOT TREAT AS A SIMPLE CUT.
• Go to an emergency room immediately.
• Tell the doctor you suspect an injection injury.
• Tell him what kind of material you were spraying with and
have him read
NOTE TO PHYSICIAN
above.
NEVER
alter equipment in any manner.
NEVER
smoke while in spraying area.
NEVER
spray highly flammable materials.
NEVER
use around children.
NEVER
allow another person to use sprayer unless he is
thoroughly instructed on its' safe use and given this
operators manual to read.
ALWAYS
wear a spray mask, gloves and protective eye
wear while spraying.
ALWAYS
ensure fire extinquishing equipment is readily
available and properly maintained.
NEVER LEAVE SPRAYER UNATTENDED WITH
PRESSURE IN THE SYSTEM. FOLLOW PRESSURE
RELIEF PROCEDURES ON PAGE 8.
Keep spraying area free from obstructions.
Make sure area has good ventilation to safely remove
vapors.
NEVER
keep flammable material in spraying area.
NEVER
spray in vicinity of open flame or other sources of
ignition. Spraying area must be at least 20 ft. away from
spray unit.
HIGH PRESSURE SPRAY CAN CAUSE EXTREMELY SERIOUS INJURY. OBSERVE ALL
WARNINGS. THIS SPRAYER IS FOR PROFESSIONAL USE ONLY.
ALWAYS
set safety lock on the gun in "
LOCKED
" position
when not in use and before servicing or cleaning.
DO NOT
remove or modify any part of gun.
ALWAYS
remove spray tip when cleaning.
Flush unit with
LOWEST POSSIBLE PRESSURE.
CHECK
operation of all gun safety devices before each
use. Be very careful when removing the spray tip or hose
from gun. A plugged line contains fluid under pressure. If
the tip or line is plugged, follow the
PRESSURE RELIEF
PROCEDURE
as outlined on page 8.
TIP GUARD
ALWAYS
have the tip guard in place on the spray gun
while spraying. The tip guard alerts you to the injection
hazard and helps prevent accidentally placing your fingers
or any part of your body close to the spray tip.
USE EXTREME CAUTION
when cleaning or changing
spray tips. If the spray tip clogs while spraying, engage the
gun safety latch immediately.
ALWAYS
follow the
PRESSURE RELIEF PROCEDURE
before removing the spray tip to clean it.
NEVER
wipe off build up around the spray tip.
ALWAYS
remove tip & tip guard to clean
AFTER
pump
is turned off and the pressure is relieved by following the
PRESSURE RELIEF PROCEDURE.
INJECTION HAZARD
ALWAYS INSPECT SPRAYING AREA
WARNINGS CONTINUED ON NEXT PAGE.........
WARNINGS
MEDICAL ALERT - Airless Spray Wounds
If any fluid appears to penetrate your skin, get EMERGENCY
MEDICAL CARE AT ONCE. DO NOT TREAT AS A SIMPLE
CUT. Tell the doctor exactly what fluid was injected. Have
him read the following "NOTE TO PHYSICIAN".
GENERAL PRECAUTION
MEDICAL TREATMENT
SPRAY TIP SAFETY
TIP GUARD
SPRAY GUN SAFETY
