Airfree WM 140, Инструкция по эксплуатации

Страница: 5 / 12

5
English
Regardless of how hazardous a virus, fungus or bacteria might be they are fully destroyed by the powerful
heat inside the TSS
™
ceramic core mini ducts. The heat inside the ceramic core forces sterilised air up to
the heat exchanger causing air convection, which generates negative pressure underneath the ceramic
core, so contaminated air is “sucked” in at Airfree
®
bottom air inlets in a continuous, silent, and efficient
air flow.
Airfree
®
Description
6
5
Top lid with Air outlets (*) WM600 has 2 leds (one for reach ceramic core).
3
1
4
2
1 - Top lid with air outlets
2 - On/Off led
3 - Bottom Lid (*)
4 - Air inlets
5 - Power cord
6 - Serial number
Frequently Asked Questions
1. How do I know if Airfree
®
is no longer working?
Check the top lid, if cold the sterilisation system is not working. Please connect it to another outlet and
make sure the unit is in its vertical position for at least 1 minute.
2. Are there any side effects?
No. Airfree
®
’s new technology uses heat to purify the air with meaningless heat contribution to the room.
No side effects, no emissions, NO IONS, nor new particles are generated. Airfree
®
can be used in homes
and offices, quietly, constantly, and efficiently purifying the air.
3. Can I install Airfree
®
in my walking closet ?
Yes if larger than 2x2 meters (4 m² or 10 m³). Otherwise it might warm up the closet.
4. Can I use Airfree
®
in air conditioned rooms?
Yes.
5. Can I place Airfree
®
at the corridor to reach adjacent rooms?
No. Airfree
®
will just reduce air pollution in the corridor’s area.
6. Can I place Airfree
®
in a closed room?
Yes. Please remember such a room must have at least 4 m² (10 m³).
7. Should I turn off Airfree
®
when I leave house?
To achieve best performance we recommend to keep Airfree
®
always on. Turning the unit off will stop the
sterilisation process allowing the room contamination to grow.
8. Can I change Airfree
®
from one room to another?
Airfree
®
must always be plugged in the same room 24 hours a day. Airfree’s patented
technology works gradually so, when removing it to another room the contamination in the
original room will start to increase.
9. Does CADR measure the effectiveness of the Airfree
®
?
Not at all. CADR is not designed to test the Airfree
®
technology. The AHAM seal
(usually found on the back of an air cleaner’s box) lists three Clean Air Delivery Rate
(CADR) numbers: one for tobacco smoke, one for pollen and one for dust. The CADR
indicates volume of filtered air delivered by an air cleaner. The reason why CADR is not
designed for Airfree
®
is because Airfree
®
does not filter but destroys microorganisms
instead, such reduction of bacteria, moulds, viruses and other microorganisms can only be
measured after air sample incubation in a microbiology lab. Airfree
®
destroys (not trap or
attract to other surface) any microorganism regardless of how small they might be. 99.99% of all
microorganisms are fully destroyed when passing through the Airfree
®
patented ceramic core.
10. What happens if Airfree
®
is disconnected or there was a black out?
Airfree
®
will take approximately the same time to recover the previous reduced contamination level.