Airfree Tulip 1000, Руководство оператора

Страница: 3 / 8

3
Allow your unit to run for at least one week to achieve significant airborne mold spore
reduction. It is important to stress that Airfree ® will not destroy or remove mold from an
infected item or surface. Those surfaces must be cleaned manually since they are a continuous
source of new spores. Airfree
®
will destroy airbone molds, spores and prevents them from
contaminating other areas, inhibiting the growth of existing and new colonies.
Airfree
®
and Mold
Installing and Connecting
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons or any authorized warranty service shop to avoid
potential hazard events. When returning your Airfree ® for repair please make sure it is
well protected preferably inside its original box, to avoid additional damages.
Airfree
®
shall not be placed near flammable and toxic products.
Plug power cord into the nearest outlet. Make sure the surface is dry (never place
Airfree
®
on wet floor or immerge it in water). Make sure side led light is on. Adjust the
multi-color Night Light intensity with the touch sensor. After 30 minutes the top lid should
be warm.*
Place Airfree
®
on a flat surface preferably not exceeding 3’ from the floor, not under
furniture, shelves, or behind curtains as it will interfere with air flow and Airfree ®
efficiency in reducing destroying microorganisms.
Check if the area is compatible with the unit capacity to achieve best unit performance.
Using Airfree ® in rooms larger than its capacity will greatly reduce its purifying
capacity.
Airfree
®
must be continuously on in the same room, 24 hours a day. Nevertheless,
temporarily removing it from the room will allow new microorganism contamination to
grow but it will be destroyed when Airfree
®
is plugged in again. The longer the period
without Airfree
®
the higher the new contamination in the room.
Rooms with air condition or ventilation will not affect the air sterilization efficiency of
your Airfree
®
. Same for Heating systems.
Airfree
®
can be placed in corridors but the air sterilization effects will barely have any
effect in connecting rooms.
Airfree
®
is to be used preferably in rooms larger than 43 ft² or 353 ft³.
(*) Please see the session “Technical Characteristics“ in order to check if your model has
the multi-color Night Light feature.
Always keep Airfree ® in its vertical position as shown in the picture, otherwise the unit
will be shut off until it goes back to the vertical position. In models with Night Light
option, the illumination top leds will become intermittent.*