Airflow QT 150HT, Инструкция по установке и эксплуатации

Страница: 4 / 22

2

Ensure a uniform inflow and free outlet!

During operation within a fire place in the ventilated room,
sufficient air supply should be provided in all operating
conditions (please contact chimney sweep).
Valid local regulations and laws should be observed!

The QT150 HT fan should not to be used by children and
persons with reduced physical, mental or sensory capacities,
without proper practical experience or expertise, unless they
are controlled or instructed on the product operation by the
person(s) responsible for their safety. Children should not
play with the device. Cleaning and maintenance must not be
carried out by children without supervision.
1.3 Warranty claims – Disclaimer
All versions of this manual should be observed; otherwise the guarantee will be
annulled. The same applies to liability claims against Airflow Developments Limited.
Any potential damages are not a subject of the guarantee. Changes and
modifications to the product are not allowed and will result in a loss of conformity - in
such case any warranty and liability will be excluded.
1.4 Regulations – Guidelines
The fan should be properly installed and used for its intended purpose. The product
complies with the valid regulations and CE-guidelines at the time of its production.
1.5 Transport
The fan is factory-packed so that it is protected against normal transport loads. It is
recommended to leave the fan in the manufacturer’s original package.
1.6 Acceptance of delivery
A visual inspection upon delivery should be performed including damage and type
accuracy check. In the event of there being any damage, the necessary notification
of claim
immediately has to be reported to the carrier. Any delay in complaint will
result in a loss of benefit entitlement.
1.7 Storage
When storing for a long period of time, avoid harmful impacts by following these
steps: protect the motor by dry, air and dustproof package (plastic bags with drying
agent and moisture indicator). The product should be stored in a vibration-free and
water-protected premise at a constant temperature ranging from -20

C up to + 40

C.
In compliance to Chapter 8, when storing a product for more than three months
(motor standstill), maintenance should be determined before commissioning. In case
of transshipment (especially over longer distances: e.g. sea), the packaging has to
be checked whether it is suitable for transport and on the route. Damages caused by
improper transportation, storage or installation are not covered by the warranty.