- 8 -
next cycles will count down from 11 minutes. If you press twice, then the countdown will be from
12 minutes and so on.
Step 6
Auto clean function: before the unit is switched on, press the TIMER/CLEAN button for 3
seconds until it reflects the auto clean mode.
Step 7
Press ON/OFF button again to switch the unit off.
Care and Maintenance
1. Clean the inner liner, water box, ice shovel and evaporator frequently. When cleaning, unplug
the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the
inside and the outside surface of the Ice Maker. Do not spray Ice Maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.
2.
Keep ventilation openings clear of obstruction. Do not use mechanical devices or other
means to accelerate the defrosting process, other than those recommended by the
manufacturer.
3. To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced
every 24 hours.
4. If the compressor stops for any reason such as water shortage, too much ice, power off, etc.,
do not start the system right away. Wait 3 minutes and then re-start the Ice Maker.
5. Always fill up with fresh water.
Troubleshooting
Problem
Possible Cause
Suggested Solutions
The compressor works
abnormally
with
a
buzzing noise
The voltage is lower
than recommended
Stop the Ice Maker and do not restart
until the voltage is normal.
The
“ADD WATER” light
is on
There is no water or
water is not enough
Press the “STOP” button, fill with
water a
nd press the “START” button
again to restart.
Indicator light on the
display is not on
1.Control panel wire
line is loosened
2.Control panel is
broken
Call for service
The water is flowing, ice
is made, however no
release of ice
Temperature sensors
are connected by
mistake
Call for service
Everything is correct but
no ice is made.
1.Refrigerant leaks
2.Cooling system
blocked
Call for service