AIRFLO AFD728, Инструкция по эксплуатации, Страница: 7 / 9

4) Press the Crease Guard button if you are drying delicate or light clothes.
5) Push Start / Pause button to start desired program. If you wish to pause the
cycle to add more clothes, pust the Start / Pause button again. Be careful with
hot steam when opening the Dryer door. To continue program, make sure the
door is closed then push the Start / Pause button once again. When the Dryer
is in Pause Mode, it is possible to change or restart programs.
6) Control panel lock feature is initialized by pushing both Crease Guard and
Heat buttons at the same time. When the lock feature is enabled, it is indicated
by a light. Pushing both buttons again will disable this feature.
7) If the unit does not heat up, push the
Reset
button located at the back of the
unit.
8) During the operation of the Dryer, you can click the the Temperature Display
button to view the current temperature of the Dryer. This function will exit
1) Switch on by pressing the
Power
button.
2) If the Filter button flashes, it means to clean the Lint Filter.
After you clean the Lint Filter, close the Dryer door and press Start / Pause
button. The light should turn off.
3) Decide on a program (see diagram below) according to the texture and capacity
of the clothes.
10) A buzzer will signify that the program has ended and clothes are ready to
be taken out of the Dryer.
11) To be safe, unplug the unit after each use.
12) Clean Lint Filter, the cabinet and the inner tube. (Accumulated dust and
fiber will affect air circulation which will cause longer drying time.)
* Make sure the power is off before cleaning.
automatically after 5 seconds.
** Check label attached on clothes to choose the right temperature
and time.
9) You can preset between 1 hour to 12 hours. Just press the
Preset
button and
add desired time.
Wool
Wool
Wool / Synthetic
Unheated / To freshen up
Unheated / To freshen up
Semi dry clothes
Dry towels
Dry (Shake the quilt)
Dry (Sportswear)
Dry (Jeans)
Chemical fiber
Wool
Wool
Small clothes
Not dry clothes
Fiber wool
** Crease Guard adds an extra 30 seconds run to shake clothes in order to
protect from creasing.
** Select the “Extra Dry” program with full heat for clothes under 2.0 kg.
Make sure to open the Dryer’s door for aeration
after cleaning the inner tube.
Cleaning the Lint Filter
Cleaning Cabinet and Inner Tube
1) Remove Lint Filter
* The Lint Filter is located at the door’s
opening.
2) Clean the filter by wiping it down with a
damp cloth.
3) Once the filter is dry, return the filter to its
original position.
4) Remember to clean the filter after every
use.
Use a damp cloth to wipe the cabinet
and inner tube.