=English Version=
11
Respect the polarity:
Phase = Brown
Neutral = Blue / Grey
Pilot Wire = Black
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid danger.
Installation:
The electrical installation must comply with standards in the
country of installation (NFC 15-100 for France).
Check the tight fit of the wires into the terminals of the wall
outlet.
Note:
The instructions for programming are sent by the side-
cons signals, measured from the Neutral.
5. HOW TO USE YOUR APPLIANCE
THE SELECTOR MODE ENABLES 5 FONCTIONS :
FONCTIONS
SCREEN DISPLAY
COMFORT
Displays temperature
(e.g. 19)
Holds temperature as to thermostat
settings.
ECONOMY (SET
BACK)
EC
Holds temperature at ~-3.5°C below comfort
temperature.
ANTI-FROST
HG
Holds temperature at ~7°C to avoid frost
damage.
STOP
- -
Stops all heating functioning.
PROGRAMMATION
Displays signal of
programmer
(function light PROG)
Enables functioning as of programmed
orders.
ON/OFF SETTING (Picture here under):
To turn on the heater, put the on/off switch (on the side of the appliance)
on position 1.
For complete shutdown of the heater, turn the switch to position 0.
HEATING ON/OFF:
To start, push
MODE
button (picture cons) and the screen
will display comfort temperature (
19
).
To stop heating, push
MODE
button until “
- -
“appears
(stand-by mode).
Note
: Your settings remain in memory; the heater is just on standby.
On/Off Switch
