5
Figure 8
Figure 9
Downrod
Canopy
Set screws
Hitch pin
Lock pin
Registration slot
Step 6. Slip canopy onto downrod. Carefully reinstall
hanger ball onto rod being sure that cross pin is in
correct position, the set screw on hanger ball is tight
and wires are not twisted. (Fig. 8)
Step 7. Now lift the motor assembly into position and
place the hanger ball into the hanger bracket. Rotate
until the "Check Tab" has dropped into the
"Registration Slot" and seats firmly. (Fig. 9). The
entire motor assembly should not rotate if this is
done correctly.
6
CLOSE-TO-CEILING INSTALLATION
1. Remove the decorative canopy bottom cover
from the canopy. (Fig. 10)
2. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as
shown in Fig. 5.
3. Secure the hanger bracket to the ceiling outlet
box with the screws and washers provided with
your outlet box.
4. Remove three of the six screws and lock washers
(every other one) from the collar of top motor
(Fig. 11)
5. Place the ceiling canopy over the collar at the
top of the motor. Align the mounting holes with
the holes in the motor and fasten using the
screws and lock washers provided (Fig. 11).
6. Tighten the mounting screws securely. (Fig. 11)
WARNING:
Failure to completely tighten the three
screws in step 5 could result in fan loosening and
possibly falling.
7. Hang the fan on the hook of the hanger bracket.
Be certain that the canopy is fully locked into
hook as shown in Fig. 12. This will allow you to
make the electrical connections.
Figure 10
Figure 11
Figure 12
Canopy bottom cover
Canopy
Canopy
Collar
Hook
Screw and
Lockwasher
(3 of 6 places)
