RESTRICTED
AN
08-40SCR274-2
RESTRICTED
FRONT
RESTRICTED
AN
08-40SCR274-2
INSULATOR
ASSEMBL
Y
PLATE
SECTIONAL VIEW
SEE NOTE2
REAR
Section
V
ASSEMBL Y PROCEDU RE
A.ST R IP INSULATION ON END
OF
I'·
EACH CONDUCTOR A DISTANCE OF
e
B . TIN END O F C ONDUCTOR .
C.REMOVE INSULA TOR ASSEMBLY B Y
REMOVING T HE PHILLIPS SCREW.
O.INDIVIDUAL WIRES SHALL B E
CARR IED TH ROUGH TH E NUMBEREC
HOLES IN THE BA C K PLATE AND
SOLDERED TO THE RESPECTIVE
JACKS ON INSULATO R ASSEMBLY.
THERE SHALL BE NO CROSS-OVERS
IN
THE WIRES BET WEEN THE BACK
PLATE AND INSULATOR ASSEMBLY.
E.ASSEMBLE INSULATOR INTO SHELL
AND REPLACE SCREW.
F.
RE FERENCE MAY BE MADE TO AIR
CORPS SPECIFICATIONS AND OTHER
AIR CORPS INSTRUCTIONS
INCLUDING WIRING DIAGRAMS FOR
AD DITIONAL IN FOR MATION.
NOTES:
I. C ODE NU MBERS OF PLUGS
ILLUSTRATED
BY
THIS DRAWING
'ARE SIMILAR TO THOSE USED
WITH SHIELDED CORDAGE AND ARE
IDENTIFIED
BY
SUFFIX
''All
AFTER
THE CODE NUMBER SU CH AS
PL -153-A.
2.
THE T ERMINAL AR R ANGEMENT OF
PLUGS FOR USE WITH OPEN
WIR ING IS IDENT ICAL TO THA T OF
THE CORRESPONDING TYPE PLUG
FOR CABLE ASSEMBLIES.
Figure 5-8. Assembly Drawing of Plugs and Tuning Shaft
1 of 2
RESTRICTED
5-15