1
A
A keel is provided to give structural strength to the fuselage - it is
important that you use it because of the size of the model.
B
All parts must be cut and/or sanded down to the correct profile. There
is an engraved 'joint line' on most parts.
C
Cut out the slots for the tailplane in both fuselage halves.
D
Cut out the nose main landing-gear doors from the fuselage, and the
main landing-gear doors from the wing/fuselage lower surfaces .
Keep all these parts in a safe place until you need them.
2
A
Carefully remove any flash or casting seams from all the metal parts.
B
Make the three sets of landing gear bay components from the 2 mm
plastic sheet supplied, using the template supplied .
GENERAL
PREPARATION
FUSELAGE AND HORIZONTAL STABILIZER SUB-ASSEMBLIES
HORIZONTAL STABILIZER
FUSELAGE ASSEMBLY
WARNINGS 1 - THIS KIT CONTAINS SMALL AND/OR SHARP
PARTS. KEEP THE CONTENTS OF THE KIT AWAY
FROM CHILDREN.
2 - THIS KIT CAN CONTAIN PRECUT PARTS WITH
SHARP EDGES OR CORNERS. BE CAREFUL WHEN
YOU HANDLE THESE PARTS BECAUSE THEY CAN
CAUSE CUTS OR OTHER INJURIES.
3 - USE ALL SOLVENTS, PAINTS, FILLERS AND
OTHER MATERIAL IN ACCORDANCE WITH THE
MANUFACTURER’S INSTRUCTION. OBEY ALL
SAFETY WARNINGS.
3
.
A.
(1) Sand the tail plane parts to the correct shape.
(2) Cement the top and bottom halves of the tailplane together.
(3) When the tailplane is dry, file and sand the Leading and trailing
edges to shape.
B.
(1) Mark the position of the nose landing-gear bay on the keel (see
Figure 4), and cut it out.
(2)
Make the nose landing-gear bay.
