16
PN 28141 REV. K [10/30/2018]
14.
Set heat anticipator adjustment in thermostat (if so
equipped), by removing "R" or "W" wire to thermostat.
Read amperage draw between the two wires. Failure
to remove one of the wires from thermostat while
performing this test could burn out heat anticipator.
Set heat anticipator to amperage measured.
15.
Run furnace through at least three full cycles before
leaving the installation, to ensure all controls are
operating properly.
16.
Check all joints in any positive pressure venting system
for leaks before leaving the installation site
A.4 Special Instructions For Units Equipped With
Riello Burners
Riello specifications are listed in Table A-3.
Consult Riello Installation Instructions supplied with Burner
for specific information concerning burner adjustments,
operation, and trouble-shooting.
A.5 Final Check Out
Verify all safety devices and electrical components have
been set for normal operation.
Verify all electrical connections are tight and wiring is
secure.
Verify homeowner is informed and understands:
Where circuit breaker or fuse is located in main electrical
panel.
Where furnace switch is located, and switch "on" and "off"
positions if not obvious.
APPENDIX A - CHECK OUT AND ADJUSTMENTS
Where oil shut-off valve from oil storage tank is located.
Thermostat operation, and other related accessories.
How to operate manual reset button on primary control,
and when not to push the reset button.
How and where to visually inspect venting system for leaks
or other problems.
How to inspect, clean and replace air filter, and other
homeowner maintenance procedures.
Who to call for emergency service and routine annual
service.
Содержание BCL-190
Страница 30: ...30 PN 28141 REV K 10 30 2018 Model BCL High Capacity Diagram PARTS LISTING ...
Страница 33: ...33 PN 28141 REV K 10 30 2018 Model BCL S Diagram Fan and Limit Control Shown PARTS LISTING ...
Страница 38: ...38 PN 28141 REV K 10 30 2018 PARTS LISTING Model BFL Diagram Fan and Limit Control Shown 33 ...
