Aircare MA1201, Руководство пользователя

Страница: 12 / 41

TROUBLESHOOTING GUIDE
Trouble Probable Cause Remedy
Digital display not illuminated. • No Power.
• Power button has not been
depressed.
• Check 120 volt power source.
• Press power button once to turn
on.
Fan not operating (digital display
is illuminated).
• ROOM humidity level is not 3%
or more below SET humidity
level.
• Raise SET humidity level if
desired.
Fan running continuously. • SET humidity level is 65%.
• ROOM humidity level has not
reached 1% or more above
SET humidity level.
• A SET humidity percentage of
65% operates fan continuously.
Adjust SET level between 25% -
60%.
• Continue to run until desired
humidity level is achieved. This
may take up to 48 hours initially.
Poor evaporation of water. • CF (Check Filter) message
flashing.
• Change to a fresh new filter.
NOTE: Local water varies
from area to area and under
certain conditions mineral will
build up more rapidly in the
filter.
Bottle empties completely. • This is normal for initial filling. • Refill bottle for maximum run
time.
Bottle continues to empty after
complete filling.
• Air is entering water bottle. • Ensure fill cap is tight with no
interfering debris.
• Check for leak in water bottle.
Bottle not emptying • Base full of water. • The base will hold the
contents of water bottle (1.9
gallons/ 7.2L). Continue to
run humidifier to deplete
water from base.
CF message does not appear
even when filter is dirty or
humidifier performance is clearly
reduced.
• A loss of power has caused the
CF (check filter) message to
prematurely reset.
• Replace filter.
Fan operating slower than speed
registered on digital display.
• Humidifier is in DRY OUT mode. • Humidifier automatically
switches fan speed to ULTRA
QUIET when DRY OUT mode
message is displayed.
Humidifier not shutting off during
DRY OUT mode.
• Filter not dry. • During DRY OUT mode the
humidifier will continue to run
on ULTRA QUIET speed as
required for a 2 hour period
Controls are unresponsive or
CL is displayed CONTROL LOCK (CL)
feature has been activated.
Hold power button down
for 5 seconds. Control
Lock function will
deactivate.
12