Aircare 831000(CN), Руководство пользователя

Страница: 12 / 40

12
PROBLEM PROBABLE CAUSE SOLUTION
Unit does not operate on
any speed setting
• No power to unit.
• Unit has run out of water and
turned off automatically.
• Refill switch operation/im-
proper positioning of float
assy.
• Ensure polarized plug is fully inserted in wall
outlet.
• Refill reservoir.
• Ensure float assembly is correctly positioned
as described in “Water FiIl”
Motor does not turn on • Check motor/fan operation.
PRESSURE SWITCH
UNDERSIDE OF CHASSIS
• Wick may be incorrectly installed.
• CAUTION: Do not touch the fan when accom-
plishing this test, as the motor may turn on.
• To test the motor, turn unit ON and turn all
knobs fully ON.
• Turn the chassis over and insert finger into
tab where float rod is supposed to go. If
fan turns on, the fan and motor are working
correctly.
• Remove and reinstall wick correctly.
Display shows “00” • Unit just turned on. • Unit is initiating.
• Fan speed is in standby
Not enough humidity • Wick is old and ineffective.
• Humidistat is not set high
enough
• Replace wick when clogged or hardened
with minerals.
• Increase humidity setting on control panel
Too much humidity.
(condensation becomes
heavy on cold surfaces in
room)
• Wick is old and ineffective.
• Humidistat is not set high
enough
• Humidistat is set too high.
• Reduce humidistat setting or increase room
temperature
Water leak • Cabinet may have been
overfilled. There is a safety
overflow hole in rear of
cabinet.
• DO NOT OVERFILL cabinet. Correct water
level is indicated inside of cabinet side wall.
Odor • Clean and disinfect cabinet following Care
and Maintenance instructions.
• Add EPA registered Bacteria Treatment
according to instructions on the bottle.
• It may be necessary to replace the wick if
odor persists.
Control panel does not
respond to input. Display
shows CL
• Control lock feature has
been turned on to prevent
changes in settings.
• Press Humidity and Speed buttons at same
time for 5 seconds to deactivate feature.
Display flashes “20” • ROOM Humidity is lower than
20%.
• Will read actual humidity when level comes
up to 25%.
Display flashes ”—“ level comes up to 25%. • Will remain until humidity drops below 90%.
TROUBLESHOOTING