Air Techniques PRO VECTA HD, Руководство по эксплуатации

Страница: 21 / 35

Page 19
Air Techniques, Inc.
Usage
10 Cleaning and
disinfecting
NOTICE
Unsuitable agents and methods can
damage the appliance and acces-
sories
• Only use the disinfection and cleaning
agents specified or approved by Air
Techniques
• Observe the instructions for use of the
disinfection and cleaning agents
Wear protective gloves
Prior to work on the appliance, pull the
mains plug
The unit surface must be cleaned and disinfect-
ed of contamination or soiling Using approved
cleaning and disinfectant agents
NOTICE
Liquid can cause damage to the
appliance
• Do not spray the appliance with
cleaning and disinfectant agents
• Make sure that liquid does not get in-
side the appliance
• Remove any soiling with a soft, wet, lint-free
cloth
• Disinfect the surfaces using a disinfectant
wipe Alternatively use a spray disinfectant on
a soft, lint-free cloth Observe the disinfectant
instructions for use
Clean the outside surfaces of the unit by wiping
with a soft lint-free cloth dampened with a mild
non-abrasive household dish detergent or use a
use a quick-acting cleaning agent such as Birex,
or Isopropyl II Alcohol 70%
wipes Be careful not
to allow liquids to run or pool
The following should not be used:
CaviWipes towelettes,
CaviWipes 1 towelettes,
Sani-Cloth wipes, Volo Surface wipes,
Opti Cide 3 surface wipes,
Optim 33TB wipes,
Clorox germicidal wipes,
Maxiwipe germicidal cloth
Hold the exposure button at least as
long as the acoustic signal can be
heard Otherwise the exposure will be
faulty and there will be an error mes-
sage in the display
– The image is ready as soon as the exposure
time has passed The x-ray unit control lamp
goes out and the acoustic signal is no longer
heard
– The dose area product is shown on the
display, when this function is enabled in the
service menu
The unit cools down after every expo-
sure The cooling time is clearly dis-
played as it reduces During this time
the activation release can no longer be
operated The x-ray unit control lamp
blinks
– The unit is ready again