Air Techniques G9510A, Инструкция по установке и эксплуатации

Страница: 16 / 40

4.5 Model identification plate
The model identification plate is located on the
sensor cable and on the case.
Fig. 1: Model identification plate on the sensor
cable
Fig. 2: Model identification plate on the case
REF Order number/type number
SN Serial number
5 Function
1
2
3
4
Fig. 3: SensorX
1 X-ray sensor
2 Sensor holder
3 Cable holder
4 USB extension cord
The X-ray sensor is connected to the computer
via the sensor cable, and if required, the USB
extension cable.
The sensor is to be fitted with a hygienic protec-
tive cover and to be placed in the mouth of the
patient. It is activated via an imaging software
(e. g. DBSWIN).
During the X-ray procedure, the X-rays are
received by the scintillator (luminescent material)
installed in the sensor and are converted into
beams of light. These light beams are recorded
by the sensor as image information, digitalized
and transmitted to the computer. If an error
occurs during the transmission, the image infor-
mation is sent again.
No further X-ray image can be recorded during
data transmission.
The application part BF in accordance with IEC
60601-1 is the X-ray sensor.
Product description
14 2121100020L29 2101V007
EN-
US