1. Should be placed indoors.
2. Should be within 40 meters
of either the gateway or
another non-battery
powered Z-wave device.
3. Should not face the window
or the sunlight.
4. Should be placed on humid
/dusty place.
5. Should not be located
wherein combustible
substances or any source of
heat e.g. fires, radiator,
boiler, etc.
Choosing a Suitable
Location
08
1. Red& Green Blinking by
turns: The device is not
included in a Z-Wave
network.
2. Solid Green : The device is
included in a Z-Wave
network.
3. Green Blinking : The device
is in auto inclusion mode.
LED Indication
09
Detailed Setup
10
For more detailed information
about the hardware setup and
additonal function please see
the full user guide on
www.airlive.com.
• Press "START INCLUSION"
• Start to include a device.
Include RGBW
Controller -3
06
When the device is being
included, APP will configure
the setting into gateway.
Include RGBW
Controller -4
07
FCC Interference Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Warning
Do not dispose of electrical appliances as unsorted municipal
waste, use separate collection facilities.
Contact your local government for information regarding the
collection systems available.
If electrical appliances are disposed of in landfills or dumps,
hazardous substances can leak into the groundwater and get into
the food chain, damaging your health and well-being.
When replacing old appliances with new once, the retailer is legally
obligated to take back your old appliance for disposal at least for
free of charge.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to
radio waves. This device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg. Tests for SAR are conducted using standard operating
positions accepted by the FCC with the EUT transmitting at the
specified power level in different channels.
The FCC has granted an Equipment Authorization for this device
with all reported SAR levels evaluated as in compliance with the FCC
RF exposure guidelines. SAR information on this device is on file
with the FCC and can be found under the Display Grant section of
LED
