11
MN-962
fig. 19
TIPS FOR INSTALLING AIR LINES
When cutting air lines, use a sharp knife or a hose
cutter and make clean, square cuts (Fig. 19). Do
not use scissors or wire cutters because these
tools may deform the air line, causing it to leak
around fittings. Do not cut the lines at an angle.
Do not bend the 1/4” hose at a radius of less than
1” or bend the 3/8” hose at a radius of less than 1
1/2”. Do not put side load pressure on fitting. The
hose should be straight beyond the fitting for 1”
before bending.
Inspect hose for scratches that run lengthwise
on hose prior to installation. Contact Air Lift
customer service at
(800) 248-0892 if the air line
is damaged.
Go to air-lift.co/cuttingairline to watch a
video demonstrating proper air line cutting.
7. Cut off the air line, leaving approximately 12” of extra air line. A clean square cut will
prevent leaks. Insert the air line into the air fitting. This is a push-to-connect fitting.
Simply push the air line into the 90-degree swivel fitting until it bottoms out (9/16” of
air line should be in the fitting).
RideControl
Содержание RideControl 59570
Страница 2: ......
Страница 21: ...19 MN 962 Notes RideControl...
Страница 22: ...20 MN 962 Notes RideControl...