LoadLifter 5000 Series
MN-1047
6
4.
Driver’s side only: Insert a 5/16” bolt (O) into the small hole on the lower bracket (B)
before attaching the lower bracket to the air spring assembly (Fig. 3).
5.
2500 HD models only: Install a 3/8” bolt (U) and lock nut (L) through the hole in the
lower bracket (Fig. 2) with the head of the bolt facing down. Tighten securely.
6. Insert two 3/8” carriage bolts (I) through the large holes and into the square holes of
the legs in the lower bracket (Fig. 3).
7. Attach the lower bracket (B) to the bottom of the air spring assembly using two 3/8”
flat-head screws (P). Tighten securely.
fig. 4
Outboard
Inboard
Slot A Slot B
NOTE:
The elbow fitting will
point toward the rear of the
vehicle on the driver’s side and
toward the front of the vehicle
on the passenger’s side.
Lower
bracket (B)
Roll plates (D)
3/8”
Carriage
bolt (I)
Elbow fitting (E)
3/8” Bolt (G)
3/8” Lock washer (K)
3/8” Flat washer (J or V)
3/8” Bolt (U)
3/8” Nylon lock nut (L)
3/8” Flat-head
screw (P)
5/16” bolt (O)
Upper
bracket (A)
fig. 3
Air spring (C)
