#10-32x1/2" Phillips
Washer Head Screw
Blade
Bracket
Blade
Screws
Figure 11
Figure 12
Blade Bracket
Motor Hub
1/4-28x7/16"
Phillips Pan Head
Screw
Chain
Reversing Switch
www.airkinglimited.com
980051015 Rev B. 9-05
5 of 8
3.
Place one of the 1/4-28x7/16" Phillips pan head screws into one
of the recessed holes in the blade bracket. Turn screw until it
mates with the threaded hole in hub. Do not tighten screw
completely at this time
(Figure 12)
.
4.
Install the second screw in the same manner, then tighten both
screws firmly. Install the remaining blade assemblies in the
same manner.
5.
Install the fans pull cord chain by connecting the included ball
and string to chain coming from fan’s motor.
SECTION 10
Operation
1.
Restore electrical power to the electrical box by turning the
electricity on at the main service panel.
2.
Check the operation of the fan by gently pulling the chain switch.
3.
If airflow is desired in opposite direction, turn your fan off and
wait for the blades to stop turning, then slide the reversing
switch
(Figure 13)
to the opposite position, and turn the fan on
again. The fan blades will turn in the opposite direction and
reverse the airflow.
Figure 13
4.
This unit is equipped with a four position, three speed pull chain
switch:
1st pull = High
2nd pull = Medium
3rd pull = Low
4th pull = Off
SECTION 11
Maintenance and Cleaning
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
WARNING:
DO NOT DEPEND UPON THE FAN’S CONTROLS
AS THE SOLE MEANS OF DISCONNECTING POWER WHEN
INSTALLING OR SERVICING THE FAN. ALWAYS TURN POWER OFF
AT THE MAIN FUSE BOX.
WARNING:
DO NOT USE WATER WHEN CLEANING. IT
COULD DAMAGE THE MOTOR OR BLADES AND CREATE THE
POSSIBILITY OF AN ELECTRICAL SHOCK OR FIRE.
CAUTION:
DO NOT USE GASOLINE, BENZINE, THINNER,
HARSH CLEANSERS, ETC., AS THEY MAY DAMAGE THE FAN.
1.
Use only a soft brush or lint free cloth to avoid scratching the
finish. Abrasive cleaning agents are not required and should be
avoided to prevent damage to the finish.
NEVER USE ANY
ABRASIVE PADS OR SCOURING POWDERS.
NEVER IMMERSE
ELECTRICAL PARTS IN WATER.
2.
The fan is permanently lubricated and does not require oiling.
