the wall switch to both the red wire from the fan’s light
receptacle and the black wire from the fan’s exhaust
receptacle. Connect the ground wire from the house to the
green wire from the fan’s grounding screw (
Figure 10)
. Use
approved methods for all connections.
4.
Carefully tuck wire back inside wire compartment and replace
wire compartment cover securing with the screw that was
removed earlier.
SECTION 6
Completing the Installation
1.
If the fan’s blower assembly was removed during the wiring
process, reinstall the blower by reversing the directions in
Step 1b
in
Section 5
Wiring
.
2.
Insert the fan’s plug into the receptacle (
Figure 7)
.
3.
Plug cord from lamp holder into the appropriate receptacle
(Figure 11)
.
4.
Line up slots in the grill with lances on inside of housing. Insert
included #8 screws through grill slots and into housing lances.
Tighten both screws until the grill fits snugly to the ceiling. DO
NOT OVER TIGHTEN (
Figure 12)
.
www.airkinglimited.com
210572216 New 7-06
4 of 12
CAUTION:
FAILURE TO SECURE THE GRILL MAY RESULT
IN A RATTLING OR HUMMING NOISE.
5.
Install 1 - 100 watt maximum, type A19 medium base
incandescent bulb (not included).
6.
The base installed in
Step 4
has a set of mounting hooks
for the glass light lens. One of the hooks is in a fixed position
while the other has a tension spring. The light lens has a
notch on either side of the lens. Slide one of the notches
into the fixed position hook. Then pull the other hook out
until the lens is able to fit into position and carefully release
the hook to slide the lens into the second notch. Make sure
the glass is held securely in place (
Figure 13)
.
7.
Restore power and test your installation.
SECTION 7
Use and Care
CAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
1.
Cleaning the Grill:
Refer to instructions in
Section 6
Completing the Installation
, to remove grill and glass light
lens. Use a mild detergent, such as dishwashing liquid, and
dry with a soft cloth. NEVER USE ANY ABRASIVE PADS OR
SCOURING POWDERS. Completely dry all parts before
reinstalling. Refer to instructions in
Section 6
Completing the
Installation
, to reinstall grill and glass light lens.
2.
Cleaning the Fan Assembly:
Wipe all parts with a dry cloth
or gently vacuum the fan. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
CAUTION:
ALLOW BULB TO COOL BEFORE REPLACING.
3.
Changing the Light Bulb:
Disconnect power to the unit.
Remove glass light lens from grill by pulling the tension
springed hook outward and sliding the glass out of the hooks
(Figure 13)
. Replace with a 100 watt maximum, type A19
medium base incandescent bulb. Refer to instructions in
Step 6
of
Section 6
Completing the Installation
, to reinstall
the light lens.
Figure 10
Ground
Hot (Red)
Supply
from
house
White
Figure 11
Cord
Lamp
Holder
Grill
Lances
#8 Screws
Figure 12
Lens
Figure 13
Lens
Hook
Tension
Spring
Notch
