2.
Continuous Ventilation:
For two speed fans wired for continuous ventilation with the
recommended AKS3 switch (not included). Properly ground the switch. Connect the Black
(Hot) wire from the supply to both the Blue wire of the fan and a black wire run to the
common terminal of the wall switch. Run 3 wires from the wall switch (not included) to the
fan. Connect the Yellow wire from the fan to the top terminal of the AKS3 switch. This is
the light control. Connect the Purple wire from the fan to the middle terminal of the AKS3
switch. This is the night light control. Connect the black wire from the fan to the bottom
terminal of the AKS3 switch. This is the fan control and closing the switch will change
from normal to high speed
(Figure 8).
3.
Intermittent Ventilation:
For two speed fans wired for intermittent ventilation with the
recommended AKS4 switch (not included). Properly ground the switches. Run a wire
from the Blue wire in the fan to the Common terminal of one of the switches. Connect the
Black wire from the power source to the top terminal of the switch. This will turn the fan
on and off. Run a wire from the Black wire in the fan to the bottom terminal of the same
switch. This is the fan speed control and closing the switch will change from normal to
high speed. On the second switch run a Black (Hot) wire from the supply to the common
terminal of the switch. On the same switch run a wire from the Yellow wire in the fan to
the top terminal of the switch. This is the light control. Run a wire from the Purple wire in
the fan to the bottom terminal of the switch you just connected the yellow wire to. This is
the night light control
(Figure 9).
www.airkinglimited.com
A210952014 Rev. B 10-12
3 of 12
NOTE:
The fan’s receptacle wires might need to be pulled outside compartment for connection.
Only pull the three loose wires outside of compartment. Additional wires will be present.
4. Carefully tuck wires back inside wire compartment and replace wire compartment cover
securing with the screw that was removed earlier.
SECTION 6
Completing the Installation
1. If the fan’s blower assembly was removed during the wiring process, reinstall the blower
by reversing the directions in
Step 1b
in
Section 5
Wiring
.
2. Plug the fan’s 5 pin quick connect motor cord into the receptacle on the side of the
wiring compartment cover and the light’s 4 pin quick connect into the receptacle on
the top of the wiring compartment cover. These cords will only fit one way into the
receptacles
(Figure 10)
.
3. Install the included 26 watt fluorescent lamp into the lamp holder by lining up the pins
on the lamp base to the socket of the lamp holder and turning the lamp body clockwise
until the lamp snaps into place and is firmly seated in the lamp holder. Install a 4 watt
maximum type C7 (candelabra base) night light (not included) into the side lamp holder
(Figure 11).
4. Install the grill by squeezing the two ends of the springs together and installing them up
into the slots on the fan’s housing. Push the grill up into position
(Figure 12).
5. Restore power and test your installation.
Figure 7
Screw
Wire Compartment
Cover
Figure 10
Figure 8
Supply from
house
Hot (Black)
Blue
Black
Black
Switch
Neutral (White)
Ground
(Green or
Bare)
Yellow
Purple
Figure 9
Supply from
house
Hot (Black)
Black
Blue
Neutral (White)
Ground
(Green or
Bare)
Yellow
Purple
Black
Switch
Switch
Figure 12
Figure 11
Lamp
Lamp Holder
Pin
Night Light
Socket
