To drive on walls and upside down, you must have switch positioned
to the left.
NOTE:
Avoid driving overhead when other people are around. Do not
stand underneath when driving overhead.
To drive on the ground you must have the switch positioned in the middle.
The fan will not turn ON, but the green light on top of vehicle will turn
on and will drive properly on the ground. (The ground mode saves the
battery charge.)
The fabric air skirts can be adjusted outward at a 45º angle to ensure
proper wall suction.
IMPORTANT: The Zero Gravity Laser™ should only be driven
on smooth, clean, flat surfaces. Dirt or debris can get inside the fan
and cause damage.
When finished with your Zero Gravity Laser™ Wall Climber, remove vehicle from wall.
Turn vehicle OFF. Turn the controller OFF.
Turn the controller “ON”.
Pull the trigger on controller to emit a beam, point
the beam at the wall or ground in front of car.
The car will chase the beam from controller, as
you move the beam across the wall or ground.
DRIVING ON WALLS OR UPSIDE DOWN
DRIVING ON WALLS OR UPSIDE DOWN
DRIVING SEQUENCE
DRIVING ON THE GROUND
W
G
OFF
W
G
OFF
CHARGE
OFF
ON
PROBLEMS? Before you return to retailer, please call our HOTLINE for assistance,
1-800-622-8339
2
