AIR GAP Fluidmaster 6000 Series Скачать руководство пользователя страница 6

Страница: 6 / 8

6000 Series AirGap™ Installation Guide

Installation

Step 6

Install the valve through the cistern fixing
hole with the

washer

inside the cistern

and the

nut

on the outside. Ensure the

valve is not fouling on the cistern walls
or flush mechanism.

Step 7

Tighten the

nut

by hand and then by ½

to ¾ of a further turn with an
appropriate spanner/wrench, to
achieve an adequate seal. Be careful
not to rotate the valve and

do not

overtighten.

Step 8

Turn the water supply back on ensuring
there are no leaks and the flush is
operating correctly.

Note:

There will be a delay between float lift

and valve shut-off and initial cycles of a new
valve may be accompanied by a slight noise.

Содержание Fluidmaster 6000 Series

Страница 1: ...ation Guide Bottom entry valve assembly Float adjustment screw 1 Cap 2 Anti siphon vortex generator 3 Float chamber locking sleeve 4 Washer 5 1 2 or 3 8 BSP threaded shank 6 Nut 7 Pre fitted flow controller and filter 8 INSTALL WITH CONFIDENCE ...

Страница 2: ...Series AirGap Installation Guide Side entry valve assembly Float adjustment screw 1 Cap 2 Anti siphon vortex generator 3 Float chamber 4 Washer 5 1 2 or 3 8 BSP threaded shank 6 Nut 7 Pre fitted flow controller and filter 8 ...

Страница 4: ... your cistern Drain all water from the cistern and disconnect valve supply pipework Step 3 Remove the old valve from the cistern and ensure the fixing hole area is clean and free of debris or anything which may impair sealing Step 1 Turn off the water supply to the toilet using isolation valve or mains stopcock ...

Страница 5: ... will benefit from the removal of the flow controller and filter Mains water or pumped installations require the filter restrictor to be fitted Note For side entry valve ensure the flow controller and filter is fitted in the orientation as shown Step 5 Check that the sealing washer is pushed fully onto the threaded shank ...