Air Force F-19 Gen3, Руководство пользователя

Страница: 21 / 28

Page| 21
Operating the Machine
Cutting Flat Landscapes
Begin at the edge of the lawn and mow in a straight line back and forth as
you would with a regular walk behind machine.
Caution: Never stand below or beside the machine while mowing an
embankment. Always stand higher on the slope than the machine.
Cutting Slopes and Banks
Begin at the top and swing the machine from side to side while carefully and
slowly moving down the slope. Keep the machine moving to reduce strain
on the engine.
Stopping the Machine
Release the OPC Bail Arm to stop the machine. If the engine fails to stop,
pull the spark plug lead loose from the engine.
Cutting Height Adjustment
Your machine is shipped with the cutting disc in the highest position. Follow
these steps to adjust to the desired height of cut:
(1) Turn the petcock to the “ off ” position.
(2) Disconnect the spark plug.
(3) Tilt the machine onto its left side, keeping the carburetor up.
(4) Wearing protective hand gear, remove the Disc Securing Bolt
with holding the cutting system.
(5) Remove the three spacers and the cutting system.
(6) Reposition the spacers and cutting system for desired height of
cut.
(7) Fit the Disc Securing Bolt back to the machine.
Bolt should be
installed to 18ft pounds of torque.
Note: Large spacer must be positioned directly below the impeller at all
times.
Prevent An Accident
Inspect the cutting area before using the mower. Any objects other than grass
and leaves should be removed to prevent them from becoming projectiles.
Inspect for hidden obstructions, which would cause health and safety risks
when coming in contact with the cutting system. Make note of the
obstructions and mow around them.