Aiphone GT SERIES, Руководство по установке

Страница: 20 / 24

20
ON
OFF
2 3
1
SW2
1 2 3 4 5 6 7 8
SW3
1 2 3 4
ON
OFF
ON
OFF
The multi building control unit, GT-MCX, needs to be initially set up via the DIP switches before powering on. The IP address will be assigned
based on the section ID setting. (192.168.1.50 + Section ID)
Confi guration will then need to be completed using the GT Setup Tool on a PC.
* Refer to the
GT SYSTEM Multi Building System Setting manual for details about confi guring the system settings.
* It is recommended to discuss the installation and setting method with the person responsible for installation in advance.
1
Power switch
Set the switch to ON when using this unit.
2
SW2
No. Function Default
2 to 6 Sets the local section ID.
See "
Section ID setting " below for
details.
OFF/OFF/OFF
OFF/OFF/OFF
(ID 1)
8 Resets the passcode for the installer or
administrator when this unit is
initialized by setting this switch to ON. OFF
3
SW3
No. Function Default
1 Sets whether DHCP is active or not.
ON: DHCP is inactive.
An IP address decided by the PC Link
Setting method will be assigned to the
unit.
(Default IP address - 192.168.1.50)
The IP address is set as follows.
192.168.1.
α
(
α
= 50 + Section ID)
[Example]
Section ID = 11
IP Address = 192.168.1.61
* For detailed explanation of IP setting,
please refer to GT SYSTEM Multi
building system Setting manual.
OFF: DHCP is active.
An IP address will be assigned
automatically.
OFF
2 Initialization of the settings.
* The set date is not initialized.
Follow the procedure below.
OFF
How to initialize GT-MCX (
3
SW3 - "2")
Procedure:
1
Turn the power switch OFF for the unit to be
initialized.
2
Set the DIP switch "2" in SW3 to ON position.
3
Turn the power switch ON.
The status LED of the unit will fl ash for approximately 30
seconds; wait until the LED stops fl ashing.
* In the case date & time has not been set, the LED will
continue to fl ash in approximately 6 second intervals after 30
seconds have passed.
4
The unit has now been initialized. Set the DIP switch
"2" in SW3 to OFF position.
5
Turn the power switch ON.
This step completes the initialization procedure.
NOTE :
ID1 is unavailable for the entrance station and the guard station.
( ID1 of each station is used for GT-MCX in a multi building
system.)
5 SWITCH SETTINGS
Power switch
DIP switch
: Do not change these switches.
Entrance station
(GT-DMB-LVN,
GT-DMB-N)
Guard station
(GT-MKB-N)
ID1 is unavailable.
Audio module
(GT-DB, GT-DB-V, GT-DB-VN)