Aiolos PuriClean PuCl-1000-U, Руководство пользователя, Страница: 14 / 16

UNIT FUNCTIONS
3. Alarms
3 different alarms can be displayed.
1. "PRE FILTER“ Alarm
This alarm is timed and is displayed after 1,000 operating
hours. This corresponds to a minimum filter maintenance at
average pollution conditions.
The filter alarm is reset after cleaning by pressing "FAN
SPEED". Press and hold the key for about 5 seconds. Then the
warning light goes out.
2. "HEPA" -Alarm ; The Hepa filter lights up when it reaches
the full level that affects the performance of the device. If you
replace the HEPA filter, the filter differential pressure sensor
will detect it and the warning light will go out.
3. "UVC" Alarm . This alarm is timed and is displayed after
9,000 operating hours or if the lamp is defective. After
replacing the UV-C lamp
The "UVC" alarm is reset after the UV-C lamp has been
replaced by pressing "FAN SPEED". Press and hold the key for
about 5 seconds. The warning lamp then goes out.
The UV-C lamp must be disposed of in accordance with the
applicable waste disposal laws!
1
2
3
Possible errors / Problem solving
Error Possible causes Solution
Unit does not work
Checking the electrical
Connections
Visual inspection and checking whether
plug connections are correctly positioned.
Is voltage available at the socket?
The device does
not blow out air
Check whether suction and
discharge openings are blocked
Foreign body covers from the device
remove. Keep distance from the wall.
Fan does not run? Ensure that the ON switch is activated
Das Gerät filtert nicht
ausreichend
Are the air inlets and outlets free
accessible?
Eliminate possible blockages and
pay attention to the necessary distance
Filters have not been used for a long time
cleaned.
Filter cleaning / change.
Luft aus dem Gerät riecht
nicht frisch
Strong cigarettes or similar
in the room air.
Odour fades after some time,
because the effect of the activated
carbon filter takes effect.
Filter service life and contamination
monitor.
Filter replace and clean the device
UV-C Lamp does not work.
UV-C Lamp activated? UV-C Lamp switch on at the
control panel
UV-C Checking the lamp contact
in the bracket.
UV-C making contact
Check fuse, otherwise consult
a qualified technician.
Technische Änderungen vorbehalten. Abbildungen und Angaben unverbindlich.
14
Operation
EN