6
e
g
a
P
Operation
Warning: NEVER operate this inverter unless it is properly grounded.
1. Open the rubber cover on the receptacle(s) and plug the 115 VAC device(s) you
wish to power into the 3-prong AC Receptacles. See
FRONT above. The
appliance(s) must not use more than 2500 (total) watts during continuous
operation, otherwise it may overload the Inverter.
Caution: Some rechargeable appliances may damage the Power Inverter or
the appliance. When first using a rechargeable device, check the inverter’s
temperature for the first 10 minutes. If it becomes abnormally hot, do not use
this device with the Inverter. You should consider using a Pure Sine Wave
Inverter instead.
2. Flip the Power Switch to the On (I) position to turn on. Do not use the appliance
until the green power LED indicator is on.
3. Turn on appliance. If an alarm sound is heard, turn off the appliance.
Caution: It is recommended that the vehicle be started every hour to recharge
the battery system. Doing this will help prevent any unexpected shutdown of
the equipment. This will also help ensure that there will be enough battery
power to start the vehicle. Due to the risk of carbon monoxide inhalation (see
Warning # 2
on page 4), do not run the vehicle’s engine within an enclosed
area.
4. After use, disconnect the appliances, flip the Power Switch to the Off (O) position,
5
. Display:
DC Input Voltage Indicator :
Output Power Indicator :
7 Green LED indicate 22-30V Range step: 1V
1 orange LED indicating lower than 22V
1 Red(Bottom) LED indicating lower than 21V
1 Red(Top) LED indicating above 30V
and put the rubber covers back in place over the receptacles.
FRONT
Outlets
(covered)
Power
Indicator
Switch
Display
Remote
8 Green LED indicate,step 250 Watts, up to 2000 Watts
2000 Watts, up to 2250 Watts
1 orange LED indicate,step
1 red LED indicating,The output load is more than 2250 Watts
