Camera Module with
Mounting Bracket
Front
Cover
Tamper-resistant screw;
use wrench supplied.
Use back cover as a template to mark hole
locations. Install anchors according to the wall
construction. Use 1/4-inch or 6 mm screws.
Back Cover
Conduit plugs, 2 supplied;
use where required.
7
3. DESCRIPTION
The MLAC Series Corner units are small, high security surveillance cameras
for corner applications.
MECHANICAL
Construction/Finish: Polycarbonate dome and cast aluminum housing.
4. INSTRUCTIONS
1. Check to make sure you have received the corner housing and the separate
camera module.
2. Disassemble housing using provided security wrench.
3. Using rear cover as a template, mark screw holes on the corner wall (see
Figure 1).
Figure 1 MLAC Corner
Warning: This is a Class A product. In a domestic environment,
this product may cause radio interference in which case the user
may be required to take adequate measures.
6
FCC & ICES INFORMATION
(U.S.A. and Canadian Models Only)
WARNING - This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of Industry
Canada.These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.This equip-
ment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the inter-
ference at his own expense. Intentional or unintentional changes or modifications not
expressly approved by the party responsible for compliance shall not be made. Any
such changes or modifications could void the user's authority to operate the equip-
ment.
If necessary, the user should consult the dealer or an experienced radio/television tech-
nician for corrective action.The user may find the following booklet prepared by the
Federal Communications Commission helpful: "How to Identify and Resolve Radio-TV
Interference Problems." This booklet is available from the U.S. Government Printing
Office,Washington, DC 20402, Stock No.004-000-00345-4.
1. UNPACKING
Unpack carefully.This is an electromechanical device and should be handled
carefully. Check to ensure that the following items are included:
■
Housing
■
Camera Module
■
Hardware Kit:
• Extra tamper-resistant screw
• Tamper-resistant hex bit wrench
• 2 conduit hole plugs
2. SERVICE
If the unit needs repair service or parts, the customer should contact Aigis
Mechtronics for authorization to return as well as shipping instructions.
