7
6. MOUNTING
1.
Determine a secure mounting location.
2.
Cautions:
a.
For a secure installation, use four 8-mm (5/16-in)
diameter fasteners (not included). Use stainless steel
or zinc plated fasteners.
b.
If bolts are used, they should extend through the
mounting surface and be secured with flat washers,
lock washers, and nuts on the opposite side. Each
bolt must have a minimum pull-out strength of 200 kg
(450 lb).
c.
If studs are used, they should be anchored in
concrete or welded to a steel backer plate. Each
stud must have a minimum pull out strength of 200 kg
(450 lb).
c.
If studs are used, they should be anchored in
concrete or welded to a steel backer plate. Each
stud must have a minimum pull out strength of 200 kg
(450 lb).
d.
If the wall mount is attached to wood or to a blind
structure (with no access to the rear), each fastener
must have a minimum pull-out strength of at least 200
kg (450 lb).
3. Locate the four holes or stud locations using the flange as
a template (four holes equally spaced on a 69.9-mm (2-3/4-
in bolt circle).
4. Install the mount using bolts or studs at least 8-mm (5/16-
in) in diameter.
5. Turn the housing into position and lock the mounting head
in by using the supplied 1/8 long-arm hex wrench to
tighten screws.
For more information see the MT9208SS & MT9212SS
Stainless Steel Mount Instruction Booklet.
7.
DIMENSIONAL OUTLINES
mm
in
95,3
3.75
3/4-14 NPT
PIPE THREADS
ø
HS9383S-6H
17.72
450.1
HS9383S 300.2
11.82
HS9383S-2H
HS9383S-5H
