6
3. Replace the rear retaining ring by inserting it into the
housing groove. This secures the cradle assembly in the
housing. If the housing needs to be tamper-resistant, the
HS9380TK (purchased separately) should be installed at
this time.
4. Attach the housing to the appropriate mount using
instructions provided with the mount. According to the
orientation of the housing, the cradle assembly may need
rotating to align the camera image. To rotate the cradle
assembly (while mounted), use 1-3/4 wrench or channel
lock pliers to grasp the flats on the raised section of the
rear cap to rotate to the desired position. This is best
accomplished while viewing the image on the monitor.
See
Figure 8.
5.11
Installing Conduit
1. Apply pipe sealant or teflon tape to the threaded section
of the conduit fitting.
2. Install fitting in the rear cap and tighten with an adjustable
wrench.
Figure 9: Rotate Cradle Assembly
5.9
Desiccant Bag
There is one desiccant bag provided with this housing to
absorb moisture. Remove the adhesive strip on the back
of the desiccant bag and adhere the bag to the cradle in a
location that will not interfere with the camera or sliding
the cradle back into the housing.
5.10
Re-installing the Cradle Assembly
1. Place the cradle in the housing, push the front cap of the
cradle past the rubber o-ring in the rear of the housing,
stop pushing when the rear cap of the cradle is touching
the o-ring in the rear of the housing.
2. Insert the tip of a flat head screwdriver in the slot of the
housing, lay the screwdriver across the raised section of
the rear cap, and push in towards the housing to close
the cradle.
See
Figure 8
.
Figure 8: Inserting Cradle Assembly
Black
115 VAC
Input
White
Red
24 VAC
White/
Black
Striped
To Heater/Defogger
Red
White/
Black
Striped
6
5
2
1
12
11
8
7
To Camera
Figure 7: HS9383S-6H Transformer
Wired for 24 Volt Camera
5.8.3 Power Connection
HS9383S-6H
1.
Installing a 24-volt camera into the HS9383S-6H housing
utilizes the internal transformer for the camera.
2.
Pull the wires through the conduit fitting and make sure
that the threaded section of the fitting mates up with the
threads in the rear cap.
3.
Pull the wires through the threaded hole in the rear cap of
the cradle.
4.
A screw, nut and terminal lug are provided for the safely
ground.
5.
Unscrew the terminal lug and attach the ground wire.
Attach the lug back to the rail of the cradle.
6.
Connect the supply (115Vac ) to the primary flying leads
of the transformer (white wire on pin1, black wire on pin
6 ). Gray connectors have been pre wired with these
connections. See
Figure 6
. Push and hold the side of the
connector that does not have wires in it. Slide the tip of
the wires into the opening of the connector until it stops
then release. Repeat theses operations for th other side.
7.
Connect the secondary flying leads to the camera s 24-volt
input. See
Figure 7.
