4
2
SERVICE
If the unit ever needs repair service, the customer should contact Aigis Mechtronics for return authorization
and shipping instructions.
3
CARE AND MAINTENANCE
There are no moving parts in this unit. Regularly scheduled maintenance will help prolong the operation life of
this unit. Clean the viewing window as needed with a mild, nonabrasive detergent in water and a soft cloth.
4
DESCRIPTION
The HS9383S-2HP and the HS9383S-P are pressurized stainless steel enclosures designed for CCD camera
installations.
ENVIRONMENTAL ENCLOSURE
Construction
This stainless steel housing is a self contained unit with a single corrosion resistant connector for power, video,
lens control, and external sync. The camera housing is sealed at both ends by radial pressure "O" rings to
create a tight seal; front-to-back motion is prevented by a retaining ring in the front and in the back. Chemically
strengthened glass is used for the faceplate for maximum strength and safety.
The housing is fitted with a standard Schrader valve to allow pressurization with dry nitrogen to 35 kPa (5 lb
PSIG) nominal at one atmosphere. An overpressurization safety relief valve is mounted on the rear cap along
with the Schrader valve. The purpose of the relief valve is to provide a safety pressure blow-off should internal
pressure exceed 140 kPa (20 PSIG) at one atmosphere. A pressurization warning label is visible on the back
of housing.
1
UNPACKING
Unpack carefully. This is electromechanical equipment and should be handled with care.
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If
any items are missing, notify Aigis Mechtronics, LLC Sales Representative or Customer Service. The shipping
carton is the safest container in which the unit may be transported. Save it for possible future use. Verify that
the parts listed as follows have been included.
Hardware Kit
Quantity
Part Description
3
Cable Ties
2
1/4-20 x 1/4-inch Button Head Cap Screw
2
1/4-20 x 3/8-inch Button Head Cap Screw
2
1/4-20 x 1/2-inch Button Head Cap Screw
1
1/4-20 x 5/8-inch Button Head Cap Screw
1
1/4-20 x 3/4-inch Button Head Cap Screw
1
0.4 mm (0.016 in) Plastic Spacer
1
1.7 mm (0.065 in) Plastic Spacer
1
3.9 mm (0.154 in) Plastic Spacer
1
7.4 mm (0.292 in) Plastic Spacer
1
9.7 mm (0.385 in) Plastic Spacer
2
5/16 Flat Washers
2
1/4 Lock Washer
1
Bit Driver 5/32
Quantity
Part Description
1
Rear Connection Coupler
1
16 Pin Wire Harness Plug
1
Seal Sleeve
