7
Mounting System
Camera
Camera
Mounting System
Top Panel
Cover
Figure 12 Camera and Mount System
Figure 13 Camera and Mount System
5.4 Final Assembly
1.
Mount the cover by aligning the studs with the slots on
the top panel and pushing up and back. See
Figure 14
.
Figure 14: Replacing the Cover
2.
If necessary, remove cover to make any final adjustments
to the camera and camera mounting system. Replace
cover. Camera/lens should be positioned as close to the
viewing window as possible.
3.
All Models:
Secure the cover by screwing the tamper-
resistant screw or the lock down tight to the cover. See
Figure 15
.
NOTE: Retain the special tool or key for future use.
6
REPLACEMENT PARTS
& ACCESSORIES
6.1 Replacement Parts
Part No.
Description
315 2250 004
Key Hardware Kit (locking models only)
315 2250 005
Tamper-resistant Tool (basic models only)
Hardware Kit
6.2 Accessories
Defogger kits are recommended for use in areas where con-
densation could cause fogging of the viewing window.
Model
Description
HS9315-6
115 VAC, 50/60 Hz, 50 W thermostatically
controlled defogger kit
HS9315-2
24 VAC, 50/60 Hz, 50 W thermostatically
controlled defogger kit
HS9315-5
230 VAC, 50/60 Hz, 50 W thermostatically
controlled defogger kit
Do Not Exceed 30 VAC Input on 24 VAC models.
Operation above 30 VAC violates low voltage operation
(Class 2 Specifications). Normal operation is 24 VAC.
Maximum Camera/Lens Size: Housing accepts
camera/lens combinations up to 300 L x 64 W x 54 H mm
(11.8 x 2.5 x 2.1 in).
Tool
or Key
Lock or Screw
Cover
Figure 15: Securing the Cover
