AIEMERY EFD, Руководство пользователя

Страница: 9 / 21

8
3.4 Staring up
Before starting the machine, control and adjust the following items:

Tension of trapezoidal driving belt.

Oil level of gear.

Point of lubrication

All bolts, nuts and screws.
Working
Position
Moving
Position
In order to keep the machine stable, install the supporting frame on the machine when the
machine is stopped (see above drawing).
ATTENTION: When transferring the moving state of the machine to the
working state, do not stand between the machine and the
tractor.
The machine coupling is equipped with 3 pins so that the machine can be coupled with all
tractors with universal coupling with 3 pins. Each telescopic pole on the machine can be
adjusted properly according to the type of the tractor. Keep the Flail mower away the
tractor with a certain distance. The universal joint shall be tense and the largest distance
in the closed state shall be 5/10 cm.
Moving the lifting arm, and putting it between axes, insert the joint pins and fix them with
pins. Fix the lifting arm with chain and tensioning device so as to prevent lateral
movement of the machine. Connect the universal joint to the PTO shaft of the tractor on
the side of the tractor. In any event, it cannot produce a collision in any position. While
connecting 3 points, pay attention to that the PTO shaft of the tractor shall be parallel with
the ground. It is very important to keep the machine driving axle and the PTO shaft of the
tractor in parallel.
The machine shall be lifted from the ground before moving the machine.