4
Ver 1 01/2015
CLEANING
A useful guide to decontamination is MHRA leaflet DB2003(06).
Do not use abrasive cleaners as this could damage the surface of the equipment. For cleaning, wipe
with a clean cloth soaked in detergent solution and wring out. Depending on the detergent manufacturer’s
instructions the solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed periodically and the detergent
changed frequently. The detergent should be rinsed or wiped off using a clean cloth immersed in clean
water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe over with a clean cloth
and a compatible liquid disinfectant. After disinfecting clean with clean water and dry.
When using detergent or disinfectants then please refer to manufacturers’ instructions and if unsure then
consult your local Infection Control Specialist for advice.
This equipment can be cleaned/disinfected by moist heat at 80
o
C for a minimum of 1 minute or auto-
claved at 80
o
C for at least 1 minute. After cleaning or disinfecting treat all joints with a water dispersing
agent, e.g. WD40.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components for their safety.
This includes:
• Tightness of all nuts/bolts/castors and other screw in/bolt in/push in components
• Upholstery (if applicable) for security, splits, exposed staples, etc
• Straightness and integrity of all tubing and welds
If in any doubt, please do not issue or use, but immediately contact your supplier for service support.
When reissuing, a risk assessment must be undertaken as to the suitability of the Bed Lever for
the particular user and user’s bed
.
fig. 8
fig. 9
fig. 10
ASSEMBLY INSTRUCTIONS (Continued)
6. Remove the mattress from the bed and place the assembled bed lever onto the slats, making sure
that the back edge of piece C aligns with the recess of the bed (see fig 8.)
7. If not done in step 5 the width can now be adjusted to suit the size of the bed (see fig 9.)
8. Replace the mattress and the bed lever is now installed and ready to use (see fig. 10)
