Aicon Air DAC3140, Инструкция по эксплуатации

Страница: 16 / 19

DAC3140
16
5. OPERATING THE MACHINE
Before operation:
−
The device must be fitted with an adaptor for connecting to the air pressure
system. The adaptor must have ¼” threads.
−
Check that the compressor (compressed air supply) can deliver required air
volume to the device. Maximum permitted air pressure must not be exceeded.
Start switch:
−
When pressing on the start button the spindle rotates in the selected direction.
The spindle continues to rotate for a few seconds after the start button has been
released. Do not put the tool down before it has stopped rotating.
Torque selector:
The torque selector has four positions where 1 is the lowest and 4 is the highest torque.
Fitting and replacement of burr:
− Disconnect the equipment from the air supply.
− Lock the collet axel with an open wrench (11 mm). Open the collet locknut with an
open wrench (17 mm) by turning it anti/clockwise.
− Remove keys and/or adjustments tools before connecting the equipment to the air
supply.
If you are uncertain about operating the tool please contact the retailer or a
branch professional.
6.0 MAINTENANCE AND SERVICE
Before performing maintenance procedures remove the appliances from the network and
remove the compressed air from them.
•
Check and maintain the machines and safety equipment regularly.
•
Never use fuel or any other flammable liquids to clean the tools.
•
When difficult malfunctions occur, contact experienced technicians or the dealer
authorized by the importer.
Lubrication
The machine must be lubricated before use.
•
Remove the machine from the air network.
•
Turn the machine upside down and place 2-5 drops of oil to the air outlet. Only use
oil that is suitable for pneumatic appliances. Use the machine right after
lubrication.
•
Remove the excessive oil. Excessive oil damages the O-ring washers.
•
Daily lubrication is not needed if you use an oil distributor.