Aico Ei3018, Инструкция по эксплуатации

Страница: 11 / 60

11
2.1 Important Safety Instructions
Mains operated Alarms should be installed and interconnected by a qualified electrician in
accordance with the local appropriate Regulations for Electrical Installations. Failure to install
this Alarm correctly may expose the user to shock or fire hazards and damage the product.
The Alarm is designed to be permanently mounted, using its own built-in terminal block to
connect it to the mains. The mounting plate can be screwed directly to the ceiling. Alternatively,
it can be screwed to a standard junction box (BS 4662 single gang accessory box). It requires
a typical current of 3mA. The Alarm must not be exposed to dripping or splashing. There are
important markings on the underside of the Alarm.
It is a requirement that CO Alarms must be installed by a competent person.
Alternative Energy Sources - (Wind, Solar, UPS etc.)
This product is designed to be connected to a Pure or True Sine Wave 230V AC supply.
If connecting to a power source that utilises an inverter, e.g. PV solar panel, the Total Harmonic
Distortion (THD) must be less than 5%. If in doubt please check with the manufacturer of the
inverter. This also applies to battery powered UPS (Uninterruptible Power Supply) inverters.
Light Dimmer Circuits – The Alarms must not be powered from a light dimmer circuit.
Do not install Alarms in new or renovated buildings until all work is completed.
The Alarm must not be connected when the house wiring insulation is being checked with
high voltages. i.e. Do not use a high voltage insulation tester on the Alarm.