Figure 7 Foot Switch
START AND OPERATION
1.
Pull the Emergency Stop Button out.
2. Select platform on the Base/Platform control selector switch.
3.
Enter the platform by swinging the midrail entry bar in (if equipped), or raising the midrail entry bar.
4.
Attach harness and lanyards of each occupant to the lanyard anchors.
5. Depress and hold the Footswitch.
Ac
UJTION
DO NOT DISABL71
FOOT SWITCH BY
JAMMING OR ANY
OTHER MEANS.
491-0000153
Figure 7A Foot Switch Label
6.
FOOT SWITCH -
All controls except emergency stop, horn and the working lights are interrupted through this
switch. During normal operation, when the foot switch is depressed, it provides power to the platform controls
and locks out operation of the base controls until it is released.
7.
HIGH THROTTLE SWITCH-
The accelerator switch is used to increase and lower engine R.P.M..
A. With the switch in the low position engine R.P.M. is 1200 R.P.M.
B. With the switch in the high position engine R.P.M. is 2300 R.P.M.
C. With the switch in the auto position engine R.RM. is 1800 R.P.M.(if equipped)
NOTE: When elevating, rotating or extending, speed automatically shifts to 1800 R.P.M. When driving
forward/reverse control speed automatically shifts to 2300 R.RM.
8.
FORWARD/REVERSE TRAVEL CONTROL LEVERS -
To travel forward use the two travel levers. The
farther you push them forward the faster you travel. To travel in reverse pull the two levers in reverse. The
farther you pull them in reverse the faster you travel.
When the turn table is rotated 180 degrees the control levers operate in the opposite direction of travel.
Always check the arrow on the base, it indicates "FORWARD" direction. Avoid sudden direction
changes.
9.
LEFT TURN (Reverse stopped) -
With the "right" lever in the stop position, pull the "left" lever into reverse.
10.
LEFT TURN (Forward stopped) -
With the "left" lever in the stop position, push the "right" lever forward.
1 1 .
RIGHT TURN (Reverse stopped) -
With the "left" lever in the stop position, pull the "right" lever into reverse.
1 8
